WORKSHOP
Basically, a workshop is a room, area, or small establishment where manual or light industrial work is done. An educational seminar or series of meetings emphasizing interaction and exchange of information among a usually small number of participants.
We have included subjects of following three projects and also included the pdf of the report.
Please click here to download the syllabus of the Engineering Project and its introduction.
For workshop, there are three projects :
1. Sheet Metal Practice
2. Metal Cutting Practice
3. Carpentry Practice
We have included pdf copies of the report. Click here to download.
There are no books collected here, but will be provided soon.
Be careful and remember to take care of following things :
Common Mechanical Workshop Safety Rules
For workshop, there are three projects :
1. Sheet Metal Practice
2. Metal Cutting Practice
3. Carpentry Practice
We have included pdf copies of the report. Click here to download.
There are no books collected here, but will be provided soon.
Be careful and remember to take care of following things :
Common Mechanical Workshop Safety Rules
Different workshops have different work practices and different machines; however, there are certain rules that apply to any mechanical workshop of the world.
- Always wear safety gear while working in the workshop. Hand gloves, safety shoes, helmets and eyeglasses are mandatory for workshops jobs like plumbing, machine fitting, welding or carpentry. For instance, some people do not wear welding glasses while dealing with welding works. This might result in temporary or permanent blindness because welding sparks can destroy the tissues of the human eye.
- Malfunctioning machines can occur any time. It could happen during the process of screw tightening or replacing the motor of the machine. Irrespective of the type of break down, never try to work on it while the machine is on and running. Electrical components always have a scope of error, irrespective of their design, make or technology. Even if the break down is normal and requires just screw tightening, it is always advisable to switch off the machine and then do the repair. Electrical shocks can be fatal or at least be capable of damaging human cells due to the workshop machines very high power rating.
- While dealing with vehicles, always ensure that common safety guidelines are observed. Pull the hand brake, choke the rear wheels, and fit fender covers. Always jack the vehicle on a hard surface else use spreading blocks for load spreading.